beautypg.com

Electrical warning – Genie Excelerator User Manual

Page 16

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Safe-T-Beam® Sensor

(Green LED)

@)

^ ELECTRICAL WARNING

Ensure there is

No

power to

the

Opener before installing

Safe-T-Beam® System Wires. If Opener is plugged into outlet,

Unplug it now.

Safe-T-Beam® Source

(Red LED)

NOTE

The Opener will not close the door automatically unless the

Safe-T-Beam® System is installed.

Slide onto
tongue of
Bracket until^
it clicks into (45)
place

Install Safe-T-Beam® Source and Sensor

(Figure 25):

Mark both sides of garage door frame or wall 6"
above floor.

Hold Bracket against door frame or wall. Check if Bracket

extends out from wall far enough so tongue of Bracket is
beyond door, tracks, or any door hardware. If not, Safe-T-
Beam® Mounting Bracket Extensions are available from a
Genie Factory Authorized Dealer or through the
Accessories Order Form.
-

Blocks of wood, etc. may be substituted

for extensions.

Position top of Mounting Bracket at 6" mark and fasten

with 2 (#10-16

X

1-1/4") Phillips Hex Head Screws

per Bracket.

NOTE

Mounting Brackets can be attached to brick walls or concrete

floor using masonry anchors (not included).

B

Attach Safe-T-Beam® Source (Red LED) and Sensor (Green

LED) to Brackets

(Figure 25):

For single-door garages.

-

Determine which side of garage receives the most

direct sunlight, and place Source (Red LED) on this
side whenever possible.

For multiple-door garages see

(Figure 26).

-

Preventing crossed signals is critical.

-

Place Source and Sensor modules on adjacent doors

facing in opposite directions.

Top of

Bracket 6"

above
floor

Figure 25

Install Safe-T-Beams®

NOTE

To help prevent interference from the sun, the Safe-T-Beam®

Sensor (Green LED) may be placed further away from the
door opening, where it will spend more time in the shadows.

Slide the Safe-T-Beam® Source and Sensor onto the
tongues of the Brackets until they click into place.
Check final height of Lens

(Figure 27).

Top edge of Lens

5" - 6" above floor

Figure 27

Final Check Safe-T-Beams®

16

FcM' Help, call

1

-S

00

HJS

4

SEÍÍE or visit %wi»i.ferilecornparif.ccirn