Kenmore 1232 User Manual
Page 36
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
,13.'
i:
Shuttle Race Cover
C L E A W I N G A N D O I L I N G
Fig 1 Cleaning the feed dogs with a
brush.
To insure the best possible operation
of your machine, it is necessary to
keep the essential parts clean at all
times. Using a small brush, remove the
int
that
accumulates
in
the
shuttle
area and around the feed dogs.
Fig. 2 Parts of the Shuttle Assembly
To Clean the Shuttle Area:
1, This area must be kept free of dust,
lint
and
occasional
tangled
thread.
Raise the needle bar to its highest
point and remove the bobbin case.
2, Push levers of shuttle race aside and
lift shuttle race cover and shuttle
out.
3,
Clean the shuttle race with small
brush.
4,
Put a drop of oil on the center pin
of the shuttle and shuttle race, (see
arrows)
To Replace Shuttle Assembly:
1,
Position shuttle race as illustrated
so that race is forming half moon
on the left side of the machine
2,
Hold shuttle by center pin and posi
tion shuttle so as to form a half
moon
on
the
right
side
Pointed
hook will be on the bottom.
3.
Place shuttle race cover Into place
over shuttle assembly,
4. Snap the levers into position
Fig. 2