Brother FAX-150 - Manual (Page 23)

17
IV. USER-SELECTABLE SWITCH
The FAX-150 offers a number of user-selectable functions via the User Selectable Switches
which are initially programmed as 0000000 by the factory. Each of these digits is a "switch"
that controls a specific parameter of the facsimile machine.
Digits Parameters they control
Digit 1:
Digit 2:
Digits 3 and 4:
Digit 5:
Digit 6
Digit 7 The transmission speed
The presence or absence of audible tone
The resolution mode - NORMAL, FINE, PHOTO.
Length of a document that can be transmitted or copied
The presence or absence of end-of-page mark
NOT USED
The following table summarizes the digits, the items they control, the factory settings, the
optional settings and the new codes for the optional settings. Remember, the factory settings
are all Os!
Digit No. Item controlled Factory Set & Code Optional Setting & Code
1 G3 transmission speed 4800 bps (0) 2400 bps (1)
2 Audible tone Present (0) Absent (1)
3 & 4 Resolution mode NORMAL (00) FINE (10)
PHOTO (grey scale) (11)
5 NOT USED
6 End-of-page mark Present (0) Absent (1)
7 NOT USED
For example, when the factory selected for digits 3 and 4 the setting of 00, the FAX-150 will
automatically select the NORMAL mode as the "home position". However, if most of your
transmissions are of photographs, you may wish to change the "home position" to PHOTO (by
setting the digits 3 and 4 to 11. See below for the procedure.
To set a user-selectable function:
1. Turn the power OFF.
2. Turn the power ON again while depressing the FINE/PHOTO button.
3. The unit will automatically print out:
****************Qypp^jgj USER SWiTCH SETTING*************“**
* *
* USER SWITCHES: 0000000
★ *
★ *************************gpQ*j*^^p FAX 10Q***************************
The FINE lamp will blink.
4. Select the digit you wish to change and press the FINE/PHOTO button the appropriate
number of times. For example, to select digit 2, press FINE/PHOTO button twice.