Brother FAX-150 - Manual (Page 20)

14
A brand-new unit does not come with a pre-registered Remote Terminal Identification (RTI) /
Transmit Terminal Identification (TTI) number. You can register your own number of up to
twenty (20) digits. Here is an example of how you can register "201 981 0300".
As shown on page 12, the process of registering the RTI/TTI starts by pressing FINE/PHOTO
button twice in step 3. The following steps are:
4. Press the START/COPY button to print out the RTI/TTI number currently registered in
the unit. The unit will print out the following:
********************QIJPP^^-|- number *********************
* *
* RTI/TTI NUMBER:
II. SETTING THE RTI/TTI
************************ ****************************
BROTHER FAX-150
5. Press FINE/PHOTO button twice to select the first digit "2".
6. Press START/COPY button to register this selection.
7. To register the second digit - "0" - press START/COPY button. This both selects and
registers a "0".
8. Press FINE/PHOTO button once to select the third digit - "1".
9. Press START/COPY button to register this digit.
10. Press FINE/PHOTO button ten (10) times to select a space.
11. Press START/COPY button to register this space.
12. Continue this operation until you have selected and registered the final digit.
13. Press the STOP button to initiate the automatic printing of:
******* **** DO YOU WISH TO MAKE THE FOLLOWING CHANGE?
* *
* NEW RTI/TTI NUMBER: 201 981 0300
* *
********************gp^Q-yj_j^p^ FAX 1 0Q***********************************
The START/COPY lamp will start to blink when the printout is finished.
14. If your entries are incorrect, press the STOP button and then the START/COPY
button. The FINE lamp will blink. This will bring you back to step 3 where you can select
this procedure all over again by pressing the FINE/PHOTO button twice and going
through the subsequent steps.
If your entries are correct, press the START/COPY button to complete the selection of
numbers. Now you have two choices. Choice (1) allows you to continue with
registration of other parameters. To do so, you press START/COPY button again
which will bring you back to step 3 above and where you can use the FINE/PHOTO
button to select the desired parameter. Choice (2) is to terminate the registration
process by pressing the STOP button.