Brother FAX-150 - Manual (Page 21)

15
A brand-new unit does not come with a pre-registered Station ID. You can register up to fifty
(50) alpha-numeric characters for this ID. You can register a mixture of letters and numbers,
e.g., XYZ Co. District 13, or you can register all letters or all numbers. Here is an example of
how you can register an all-character ID - "BROTHER U.S.A.".
As shown on page 12, the process of registering the STATION ID starts by pressing the
FINE/PHOTO button three (3) times in step 3. The following steps are:
4. Press the START/COPY button to print out the STATION ID currently registered in the
unit. The unit will print out the following:
********************0^ppj|Cj^l” 3"|"y\”|”|Q|^ |0****************************
★ ★
* STATION ID:
* *
* * * * * * * * * * * * * * * * * * * * * * * * * * F A X 15Q***************************
5. To register the letter B, look at the table on the next page and locate "B". Underneath it
you will see the number 34. Thus, press FINE/PHOTO button three (3) times, then
press START/COPY button to register "3". Then, press FINE/PHOTO button four
(4) times and then START/COPY button to register the "4.” This registers the letter
"B."
6. To register the letter R, look at the table and locate "R". Underneath it you will see the
number 50. Press FINE/PHOTO button five (5) times, press START/COPY button to
register "5". Then, press START/COPY to register and select the "0." This registers
"R".
7. To register the letter O, look at the table and locate "O". Underneath it you will see the
number 47. Press FINE/PHOTO button four (4) times, then press START/COPY
button to register "4". Then, press FINE/PHOTO button seven (7) times and then
START/COPY button to register the "7." This registers the letter "O." Continue this
procedure until you've registered the word "BROTHER."
8. To register a space, look at the table and locate "BLANK". Underneath it you will see the
number 00. Press START/COPY button twice to register "00". This registers a blank
space.
9. Continue this operation until you have selected and registered the entire STATION ID.
10. Press the STOP button to initiate the automatic printing of:
**** DO YOU WISH TO MAKE THE FOLLOWING CHANGE? *******
★ *
* NEW STATIONS ID: BROTHER U.S.A.
* *
********************gpQ-j“l_l^p PAX 13Q***********************************
The START/COPY lamp starts to blink when the printout is completed.
III. SETTING THE STATION ID