Pioneer VSX-452 - Manual (Page 19)

REMOTÉ CONTROL OPERATION
[ LOADING BATTERIES
REMOTE CONTROL RANGE
1. Open the battery compartment cover on the rear of the remote
control unit. The cover should open easily if you slide it in the
direction of the arrow while pressing on it with your thumb.
2. Take out the two suppiied batteries size "AAA" (R03/UM-4), and
insert them into the battery compartment in accordance with the
indications in the compartment.
3. Cióse the cover of the battery compartment.
When operating the remote control unit, point the front of the unit at
the front panel of the receiver. The remote control unit may be used
within a range of about 7 meters <23 feet) from the remote sensor,
within angles of up to about 30 degrees.
Performance of the remote control unit is adversely affected in the
presence of strong fluorescent light. Keep such lights away, especially
from the sensor window.
Incorrect use of batteries may lead to leakage or rupture.
Always be sure to follow these guidelines:
A.
Always insert batteries into the battery compartment correctly matching
the positive (+) and negative (-) polarities, as indicated inside the
compartment.
B.
Never mix new and used batteries.
C.
Batteries of the same size may have different voltages, depending on
their typre. Do not mix different types of batteries.
Battery Replacement
As battery power runs down, the range over which the remote control
unit can operate decreases. When the range becomes too short, change
the batteries.
• The accessory remote control unit can be used to control some
functions of other Pioneer cassette decks, CD players, tuners,
receiver, VCRs, LD players, and TVs (only those bearing the Roneer
mark ^).
Transmit mode selector switch
AUDiO:
Select this position for remote control operation of audio equipment such
as a CD player or cassette deck.
ViDEO:
Select this position for remote control operation of video equipment such
as an LD player, VCR or TV.
-Transmit mode
selector switch
19