Pioneer VSX-452 - Manual (Page 18)

DOLBY PRO LOGIC SURROUND AND DOLBY 3CH LOGIC
LEVEL ADJUSTMENT OPERATION
1 .
6 .
7.
Use SURROUND MODE buttons to select DOLBY PRO LOGIC
SURROUND or use the DOLBY 3CH LOGIC button to switch
DOLBY 3CH LOGIC ON.
Use SPEAKERS button to turn on front speakers.
Adjust MASTER VOLUME to a suitable listening level.
Set the BALANCE control to the center position.
Sat the ramote control AUDIO/VIDEO switch to AUDIO, and then
select CENTER MODE with the CENTER MODE/TEST TONE button.
• DOLBY PRO LOGIC SURROUND: NORMAL, WIDE, PHANTOM
• DOLBY 3CH LOGIC: NORMAL, WIDE
Set the remote control AUDIO/VIDEO switch to VIDEO, and then
switch the test tone on by pressing the CENTER MODE/TEST
TONE button.
Use the remote control CENTER/REAR +, - buttons to adjust
center and rear speaker volume levels until they are the same as
the front speakers' volume level.
• CENTER LEVEL ... Set the AUDIO/VIDEO switch to AUDIO.
• REAR LEVEL ... Set the AUDIOA/IDEO switch to VIDEO.
After selecting VIDEO with the AUDIO/VIDEO switch, press the
CENTER MODE/TEST TONE button and switch the test tone to
off position.
1. Select DOLBY PRO LOGIC SURROUND with the SURROUND
MODE buttons or select DOLBY 3CH LOGIC with the DOLBY 3CH
LOGIC button.
2. Select the component for playback with the input selector buttons.
3. Set the remote control AUDIO/VIDEO switch to AUDIO, and then
select CENTER MODE wMi the CENTER MODE/TEST TONE button.
4. Begin playback.
5. Adjust volume level with the MASTER VOLUME control.
SETTING THE DELAY TIME
When using DOLBY PRO LOGIC SURROUND, you can set the delay
time between 16 ms and 30 ms. The standard setting is 20 ms, but
you can select any setting of your choice.
Set the remote control AUDIO/VIDEO switch to VIDEO, and then select
delay time with the SLEEP/DELAY TIME button. The selected delay time
is indicated in the display section.
EXTERNAL FM ANTENNA Connecting the 75 0 coaxial cable
The main advantage of FM over AM is the quality of the broadcast
signal. In order to benefit fully from the high signal quality of FM
broadcasts, it is recommended that a special-purpose FM antenna be
installed. In weak signal areas, a multi-element (3-element, 5-element,
7-element) antenna should be used.
GROUNDING
Grounding is recommended if reception of FM programs is impaired by
noise. To ground, connect a thick polyvinyl insulated wire to the GND
terminal and attach the other end to a metal water pipe or grounding
bar or wind it around a copper plate and bury it.
NOTE:
Never connect a wire to a gas pipe for grounding since sparks may ignite
the gas.
EXTERNAL AM ANTENNA
If it is not possible to obtain adequate AM reception even by changing
the orientation of the AM loop antenna, a separate indoor antenna or
an outdoor arrtenna should be installed.
INDOOR AM ANTENNA
Use a vinyl-insulated wire (5—6 m: 17—20 ft.) and connect one end
to the AM antenna terminal and affix the other end to the wall or ceiling,
as high as possible.
OUTDOOR AM ANTENNA
If reception quality is not improved sufficiently even when an indoor
antenna is used, a vinyl-insulated wire should be installed outside and
fixed in place.
NOTE:
Do not detach the AM hop antenna when using an hdoor or an outdoor
AM antenna.
18
FM outdoor antenna
AM loop antenna