Pioneer VSX-452 - Manual (Page 11)

REAR PAWEI FACILITIES
Illustration shows U.S. and Canadian models.
(z) ®
® ® ® ® ®
CD FM/AM ANTENNA terminals Page 7)
Connect to FM and AM antennas.
@ PHONO input jacks Page 7)
Connect to the output cables from a turntable.
(3) CD input jacks Page 7)
Connect to the output jacks of a compact disc player.
0GND terminal (>^ Page 7)
Connect the turntable ground lead to this terminal.
Loosen the screw, connect the ground lead, and then tighten the screw.
(5) LD input jacks Page 8)
Connect to an LD player's output jacks (audio, video).
0 REAR SPEAKERS terminals Page 9)
Connect the rear speakers to these terminals.
Use rear speakers of impedance 8 0— 16 Q.
©CENTER SPEAKER terminals Page 9)
Connect the center speaker to these terminals.
Use center speakers of impedance 8 0—16 0.
©CENTER AMP PRE OUT jack Page 7)
When a separate power amplifier is used to drive the surround center
speaker, connect the power amplifier to this jack.
©TAPE 2 MONITOR jacks Page 7)
Connect to audio components such as a second cassette deck or
graphic equalizer.
©VCR/TAPE 1 jacks Pages 7, 8)
Connect to the first cassette deck or a VCR. With a VCR, aiso connect
the video jacks.
©VIDEO OUT (TO MONITOR TV) jack Page 8)
Connect to a monitor TV.
© FRONT SPEAKERS terminals Page 9)
A: Connect to the first set of speakers.
B: Connect to the second set of speakers.
Use speakers of impedance 8 0—16 0.
©CONTROL IN/OUT jacks
IN: Connect this jack to other Pioneer components (main unit or
remote control unit) when using those components to control
this unit.
OUT; Connect this jack to other Pioneer components when using the
remote control of this unit to control the other components.
NOTE:
The receiver's remote sensor does not function when a plug is inserted
in IN jack. To operate, point the remote control unit at the remote sensor
on the component to which the receiver's IN jack is connected.
When using
the MR-100
Pioneer component
bearing the |3 mark.
Remote
control unit
To the CONTROL IN
jack of the Pioneer
component bearing
the ^ mark.
©MULTI-ROOM REMOTE IN jack
Page 10)
Connect to the separately sold MR-100 Multi-Room remote control unit.
11