Pioneer VSX-452 - Manual (Page 12)

REAR PANEL FACILITIES
©AC OUTLET
[SWITCHED TOTAL 100 W [0.8 A» MAX)
Power supplied through these outlets is turned on and off by the
receiver's POWER switch. Total electrical power consumption of
connected equipment should not exceed 100 W (0.8 A).
NOTE:
• This unit should be disconnected by removing the power plug from
the wall socket when not in regular use, e.g. when on vacation.
• Do not connect appliances with high power consumption such as
heaters, irons, or television sets to these AC OUTLET in order to avoid
overheating and fire risk.
This can cause the receiver to malfunction.
CAUTION:
DO NOT CONNECT MONITOR OR TV SET.
©AC INLET
Connect the supplied power cord.
POWER-CORD CAUTION
Handle the power cord by the plug. Do not pull out the plug by tugging
the cord and never touch the power cord when your hands are wet as
this could cause a short circuit or electric shock. Do not place the unit,
a piece of furniture, etc., on the power cord, or pinch the cord. Never
make a knot in the cord or tie it with other cords. The power cords
should be routed such that they are not likely to be stepped on. A
damaged power cord can cause fire or give you an electrical shock.
Check the power cord once in a while. When you find it damaged, ask
your nearest PIONEER authorized service center or your dealer for a
replacement.
FRONT PA1MÉL FACILITIES
CD POWER STANDBY/ON switch/STANDBY indicator
This is the switch for electric power.
ON:
When set to the ON position, power is supplied and the
unit becomes operational.
STANDBY: When set to STANDBY position, the main power flow is
cut and the unit is no longer fully operational. A minute
flow of power feeds the unit to maintain operation
readiness.
The STANDBY indicator lights when the power is STANDBY, and goes
out during ON.
[Timer ON/OFF possible]
When the unit is switched ON, ON/OFF control can be performed by
means of the optional timer.
NOTE:
When the po wer is initially turned ON, muting will be applied to prevent
sound from being output for about 6 seconds.
® BAND FM/AM button
Use this to switch between FM and AM frequency band reception.
12