Kenmore LIQUID PROPANE GAS (LPG) GRILL 119.1623 - Manual (Page 26)

USE AND CARE INSTRUCTIONS
MANUALLY LIGHTING THE BURNERS WITH
THE MATCH HOLDER
1. Open the lid.
2. Ensure all burners are in the "OFF"
position.
3. Slowly turn on the gas at the LP cylinder
valve if it is not already on.
4. Place a match in the match light stick. This
is located in the inside of a cabinet door.
5. Use the stick to slide the lit match through
the cooking grates and the front of the heat
diffuser to the burner you wish to light.
6. Press and turn the burner control knob to
"HI/LIGHT". Continue to push in and hold
up to 5 seconds or until the burner lights.
7. If the burner does not light within 5
seconds, turn the burner control knob to
"OFF". Wait 5 minutes for gas to clear, and
try again.
8. When lit, turn the control knob to the
desired heat setting
MANUALLY LIGHTING THE SIDE BURNER
OR THE BACK BURNER
1. Open the lid or side burner cover
2. Ensure the side burner and back burner
control knob is in the "OFF" position as
well as any main burner not in use.
3. Slowly turn on the gas if it is not already
on.
4. Place a match in the match holder if
lighting the back burner. This is attached
to the inside of a cabinet door.
5. Strike the match, and place near the top
of the burner if lighting the side burner
or near the center of the back burner if
lighting the back burner.
6. Push in and turn the appropriate burner
control knob to "HI/LIGHT" and hold in.
7. If the burner does not light within 5
seconds, turn the burner control knob to
"OFF". Wait 5 minutes for the gas to
clear, and try again.
8. For the back burner, continue to push
and hold the burner control knob in for 5
to 7 seconds after the burner lights until
the flame sensor begin operating.
Letting up on the burner control knob
before a high enough temperature has
been reached may cause the flame
sensor to shut off fuel to the back
burner.
9. When lit, turn the burner control knob to
its desired setting.
26