Install side burner assembly to firebox assembly – Kenmore LIQUID PROPANE GAS (LPG) GRILL 119.1623 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Install Side Burner Control Panel to Side Burner Assembly
□ Attach Side Burner Control Panel (M) to Side Burner Assembly using 3 Phillips Head
Bolts and 2 Washers. Do not use a Washer on the end Bolt.
No Washer
\i......
Phillips Head Bolt: M4x5/16"
(Black)
Qty: 3
Part # SB0009
Washer: M4
Qty: 2
Part # SB0016
Install Side Burner Assembly to Firebox Assembly.
D Loosely screw 2 Phillips Head Bolts ( M6x3/8") and 2 Washers into the upper left and
right corner holes in the left side of the firebox as shown in Inset 1. Leave 1/4" of the
bolts extending out of the firebox sides to attach the side burner brackets. Slide the Side
Burner Front and Rear Brackets over the heads of those bolts and tighten.
□ Slide the side burner ignition wire through the hole on the Side Burner Control Panel.
See Inset 2
n Use 2 Phillips Head Bolts ( M6x3/8") and 2 Washers to attach the lower holes in the Side
Burner Front and Rear Bracket to the Firebox Assembly (I) as shown in Inset 3.
Inset 1
Phillips Head Bolt: M6x3/8''
Qty: 4
Part # SB0004
Washer: M6
Qty: 4
Part # SB0005