Install side shelf assembly to firebox assembly – Kenmore LIQUID PROPANE GAS (LPG) GRILL 119.1623 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Install Side Shelf Control Panel to Side Shelf Assembly
D Attach Side Shelf Control Panel (N) to Side Shelf Assembly using 3 Phillips Head
Bolts and 2 Washers. Do not use a Washer on the end Bolt.
Washer : M4
Qty: 2
Part # SB0016
With Washer
In
Philip Head Bolt: M4x 5/16"
(Black)
Qty: 3
Part#: SB0009
No Washer
Install Side Shelf Assembly to Firebox Assembly.
□ Loosely screw 2 Phillips Head Bolts ( M5x3/8") and 2 Washers into the upper left and right
corner holes in the right side of the firebox as shown in Inset 1. Leave 1/4" of the bolts
extending out of the firebox sides to attach the side shelf bracket. Slide the Side Shelf Front
and Rear Brackets over the heads of those bolts and tighten.
Use 2 Phillips Head Bolts ( M6x3/8") and 2 Washers to attach the lower holes in the Side
Shelf Front and Rear Brackets to the Firebox Assembly (I) as shown in Inset 2.
Use 1 Phillips Head Bolt ( M4x5/16" ) to attach the Side Shelf Control Panel (N) to Firebox
Assembly (I) as shown in Inset 3.
Phillips Head Bolt: M6x3/8"
Qty: 4
Part # SB0004
Washer: M6
Qty: 4
Part # SB0005
Phillips Head Bolt: M4x5/16"
(Black)
Qty: 1
Part # SB0009
18