Removing and replacing the oven door, To remove oven door, To replace oven door – Kenmore 790.45 User Manual

Page 42: Generai care & cleaning, Care and cleaning of stainless steel, Special door care instructions

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Generai Care & Cleaning

Do not use the following on the ceramic glass cooktop:

• Do not use abrasive cleaners and scouring pads, such as metal and some

nylon pads. They may scratch the cooktop, making it more difficult to

clean.

• Do not use harsh cleaners, such as chlorine bleach, ammonia or oven

cleaners, as they may etch or discolor the cooktop.

• Do not use dirty sponges, cloths or paper towels, as they can leave soil

or lint on the cooktop which can burn and cause discoloration.

Special Caution for Aluminum Foil and Aluminum Cooking Utensils

•

Aluminum foil

Use of aluminum foil will damage the cooktop. Do not use under any circumstances.

•

Aluminum utensils

Since the melting point of aluminum is much lower than that of other metals, care must be taken when

pots or pans are used. Pans that boil dry may permanently damage cooktop by breaking, fusing to, or

AVMON

aluminum

marking it.

Care and Cleaning of Stainless Steel

(Stainless Steel models only)

Some models are equipped with stainless steel exterior parts. Special care and cleaning are

required

for maintaining

the appearance of stainless parts. Please refer to the table provided at the beginning of the

General Care & Cleaning

section in this Use & Care Guide.

Lock-

Hinge

support

I Hinge lever

Hinge lever hook

Lock engaged for door removal

Figure 1

Removing and Replacing the Oven Door

ik CAUTION

The door is heavy. For safe, temporary storage, lay the door flat

with the inside of the door facing down.

To Remove Oven Door:

Open the door to the fully opened position.

Pull up the lock located on each hinge support and engage it onto the hinge

lever hook (Figure 1). You may have to apply a little downward pressure on the

door to pull the lock fully over the hinge lever hook.

Grab the door by the sides and pull the bottom of the door up and toward you

to disengage the hinge supports. Keep pulling the bottom of the door toward

you while rotating the top of the door toward the range to completely disen

gage the hinge levers (Figure 2).

To clean oven door, follow the instructions provided in the

General Care &

Cleaning

table.

To Replace Oven Door:

1. Grab the door by the sides; place the hinge supports and levers into the

hinge slots. Open the door to the fully opened position.

2. Disengage the lock from the hinge lever hooks on both sides (Figure 3).

Note:

Make sure the hinge supports are fully engaged before unlocking the

hinge levers.

3. Close the oven door.

Special Door Care Instructions

- Most oven doors contain glass

that can break.

Read the following recommendations:

Do not close the oven door until all the oven racks are fully in place.

Do not hit the glass with pots, pans, or any other object.

Scratching, hitting, jarring or stressing the glass may weaken its structure

causing an increased risk of breakage at a later time.

Lock in normal position

Figure 3