Instructions, To set the clock (example below for 1:30), Changing between 12 or 24 hour time of day display – Kenmore 790.45 User Manual
Page 15: Press, Display, For 7 seconds, Setting oven controls, On n n, Instructions to set the clock (example below, Changing between 12 or 24 hour time
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting the Clock
The (^) pad is used to set the clock. The clock may be set for 12 or 24 hour time of day
operation. The clock has been preset at the factory for the 12 hour operation. When the
range is first plugged in, or when the power supply to the range has been interrupted, the
timer in the display will flash (See Fig. 1).
Setting Oven Controls
Figure 1
INSTRUCTIONS
To set the clock (example below
for
1:30)
1
.
Press (^).
"CLO"
will appear in the display (Figure 2).
2.
Press
Co^ pads to set the time of day to 1:30
(Figure 3).
"CLO"
will stay in the display. Press C
start
>.
"CLO"
will disappear and the clock will start (Figure 4).
Changing between 12 or 24 hour time
of
day display
Press and hold (^) for 7 seconds.
"CLO"
will appear in the
display. After 3 seconds Q will appear in the display indicating
that the cooktop lockout is active (Figure 5). CONTINUE
holding the pad until
"12h"
(Figure 6) or
"24h"
(Figure 7)
appears in the display and the control beeps once.
Press to switch between the 12 and 24 hour time of day
display. The display will show either
"12h"
(Figure 6) or
"24h"
(Figure 7).
PRESS
DISPLAY
1
.
2
.
3.
Press T
start
^,) to accept the change or press
(s^
to reject the
change. Q will disappear from the display.
4.
Reset the correct time as described in
To set the Clock
above. Please note that if the 24 hour time of day mode was
chosen, the clock will now display time from 0:00 through
23:59 hours.
©CD®
for 7 seconds
START
or (
STOP
■
■
Figure 2
on n n
O u L L U
Figure 3
on
Ou
Figure 4
Figure 5
Figure 7
15