Kenmore 1T6.31100 - Manual (Page 11)

PILE HEIGHT SELECTION AND SETTING
To selscf a pile height setting;
Turn off vacoom cleaner. Select a pile
height setting by tilting the cleaner bock
until the front wheels are lifted slightly
off the floor.
Slide the adjustment lever to the correct
setting.
There ore four (4) pile height settings on
the vacuum cleaner. Use the LOW setting
for most low-pile carpets and bare floor
cleaning {with agitator OFF), and the
HIGH setting for high-plle carpets like
shag carpet, scatter rugs, etc. Use the
other settings as needed for carpet
heights in between.
Pile Height
Adjustment
A
CAUTION
Do not allow vacuum cleaner to
remain in one spot for any length of
time when the agitator Is turning.
Damage to carpet may occur.
When the vacuum cleaner is running with
normal air flow, the light on the CHECK
BAG indicator is off. The light comes on
whenever the airflow becomes blocked. If
that occurs, check the disposabie dust bag,
motor safety filter and other possible clog
locations shown in CLOG REMOVAL.
NOTE: It is normol for the CHECK BAG
indicator to come on when using certain
attachments, due to reduced airflow
through attachment. No maintenance Is
required.