Setting oven controls, To set the clock (example below for 1:30), Ism m – Kenmore 790.7946 User Manual
Page 15: Press, Cdcd, Jn n n, Changing between 12 or 24 hour time of day display, Setting silent control operation, Instructions, Display
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting Oven Controls
•
Setting the Clock
•
Changing between
12
or24 hourdisplay
•
Silent Control Operation
Setting the Clock
The
CLOCK pad is used to set the clock. The clock may be
set for 12 or 24 hour time of day operation. The clock has been
preset at the factory for the 12 hour operation. When the range is
first plugged in, or when the power supply to the range has been
interrupted, the timer in the display will flash with power failure
"PF"
INSTRUCTIONS
To set the clock (example below for 1:30):
ISM m
PRESS
1. Press
■ "CLO" will appear in the display (See Fig. 2).
2
. Press
pads to set the time of day to 1:30
CDCD®
Fig. 2
■jn
n n
■ J U LLU
Fig.3
U^or 6 seconds
Fig. 4
or (^^
(See Fig. 3). Press
"CLO" will disappear and the clock
will start (See Fig. 4).
Changing between 12 or 24 hour time of day display:
1. Press and hold for
6
seconds untill "12h"or"24h"
appears in the display.
2.
Press to switch between the 12 and 24 hour time of day
display.
"12h" or "24h" will be displayed (See Figs. 5 or
6
).
3.
Press to accept the desired change or press to
reject the change.
4. Reset the correct time as described in To set the clock above.
Please note that if the 24 hour time of day mode was chosen,
the clock will now display time from 00:00 through 23:59 hours.
Setting Silent Control Operation
The
DELAY START (JS}and FLEX CLEAN pads control the Silent Control operation feature. The Silent Control
operation feature allows the oven control to be operated without sounds or beeps whenever necessary. If desired the control
can be programmed for silent operation and later returned to operating with all the normal sounds and beeps.
Fig. 5
S H h
Fig. 6
INSTRUCTIONS
PRESS
DISPLAY
To change control from normal sound to silent control operation:
1. To tell if your range is set for normal or silent operation press
and hold
for? seconds. (See Fig. 7)
2.
Press (^
03
) to switch between normal sound operation and
silent operation mode. The display will show either
"SP" (See
Fig.
8
) or" - (See Figs. 2 or 3).
If
"SP" appears (See Fig. 2), the control will operate with normal
sounds and beeps. If" - appears (See Fig. 9), the control is
set for silent operation mode.
3.
Press to accept the change or press to reject the
change.
for7seconds
or
Fig. 9
15