Kenmore 385.115518 User Manual
Page 36
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Set the Machine
Stitch selector
Top thread tension
control 3 to 6
Stitch length
12
Zipper foot
End of opening
Top side
of fabric
Top edge of fabric
Zipper teeth
Zipper tape
Fabric Preparation:
To Sew:
Put the top sides of the fabric to
gether and sew to the end of the zip
1.
Fold back the left seam allowance
as shown.
per opening. Use the reverse to lock
the stitches.
2.
Turn under the right seam allow
ance to form a 1/8" fold.
Sew the zipper opening with stitch
length at "6" and top thread tension
at "3".
3.
Place the zipper teeth next to the
1/8" fold and pin in place.
6
.
To sew the left side of the
2
ipper,
set the zipper foot on the left side
of the needle.
Lower the zipper foot on the top
side at the bottom of the zipper
so that the needle pierces the fold
and the zipper tape.
Sew through the fold and the zip
per tape to the point where the
slider begins.
Lower the needle to hold the fab
ric and raise the presser foot.
34