beautypg.com

Electrode check - requires an assistant, Installing cooking components – Kenmore ELITE 141.17691 User Manual

Page 11

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Electrode Check - Requires an Assistant

Before placing the cooking components into your

grill, ensure that the Spark Electrode Tip is properly

positioned vidthin each Gas Collector Box { a 4"

wide stainless mechanian found at the front be­
tween each set of Burners.) The easiest

way

to

ensure this is to perform this Electrode Check:

1. Be sure all Control Knobs are set to "OFF”

and open the Grill Lid.

2.

Have an assistant stand behind to the right of

the grill and look down at each Gas Collector

Box. NEVER put your face inside Grill Head.

3. Press the Ignitor Cap. You should hear a

"clicking" sound and your assistant should see
a small blue spark within each Gas Collector

Box. If a spark is present the Electrode Tips

are properly positioned.

4. if no spark is seen the Spark Gap shown in

Figure 4 needs to be adjusted as follows:

Using an adjustable wrench, loosen the Inside

Nut just until the Gas Collector Box can be

maneuvered and turned upward.

The gap between the Spark Electrode Tip and
Spark receiver should be approximately 3/16".

if the gap is wider than 3/16" use a pai r of long
nose pliers and gently squeeze the Gas Collector
Box until the gap is correct.

Return the Gas Collector Box to its original hori­

zontal position, secure the inside Nut and try the

Electrode Check again.

5. if no "clicking" sound is heard check the following

common causes. If you need assistance call our
Grill Information Center
at 1-888-317-7642.

ignitor AA battery not installed properly.

Electric wires may be loose. Remove the AA

battery, inspect the Ignitor Junction Box found
behind the Control Panel, and connect any loose
wires.

Figure 4 - Side View Figure

GAS COLLECTOR BOX

Installing Cooking Components

Important: Before cooking on your grill the first

time, wash the Cooldng Grids and Cooldng Rack
with warm, soapy water. Rinse and dry thoroughly.
After cooking is completed, turn grill to HIGH
setting three to five minutes to bum off rear grease
or food residue.

1. Place the four Stainless Steel Flame Tamers on

the lower ledge above Burners. See Figure 5.

2. Evenly space the Stainless Steel Cooking Grids

(cross braces are bottom side) on the ledge

above the Flame Tamers.

3. Place the Stainless Steel Secondary Cooking

Rack into the slots on the upper left and
upper right of Grill Bow! Side Panels. See
Figure 5.

4. Remove Fastening Band from Pot Support and

place the Pot Support into the Side Burner
Body-Inner. See Figure 5.

Figure 5

SIS

SECONDARY

11

This manual is related to the following products: