Kenmore ELITE 141.17691 - Manual (Page 10)

Assembly instructions
Figure 1
CAUTiON : While it is possible for one person to
assemble this grill, obtain assistance from another
person when handling some of the larger, heavier
pieces.
1. Open the parts boxes. Use the parts list to check
that all parts have been included.
2. inspect the grill fordanage as you ^semble it. Do
not assemble or operate the grill if it appears
damaged. If there are damaged or missing parts
when you unpack the shipping box, or you have
questions during the assembly process, call;
1-888-317-7642 8a.m.-8p.m CST, Mon.-Fri,
Installing Side Shelf and Cart Side Handle
1. Remove the \siiite protective film from the
stainle® steel Side Shelf.
2
.
Enlisting the aid of an assistant, attach Side
Shelf to left side of grill. Align the holes on Side
Shelf with the threaded holes on left Outside Bowl
Panel. Tighten securely using 4 of the 1/4"xS4"
Phillips Screvra provided.See Figure 1.
3.
S122G04121 Qty. 4
Phillips Head Screw 1/4"x3/4"
Enlisting the aid of an assistant, attach Cart Side
Handle to right side of grill. Align the holes on
Cart Side Handle with the threaded holes on
right Outside Bo\M Panel. Tighten securely using
4 of the 1/4"x3/4" Flat Head Screvra provided.
See Figure 2.
S142G04121 Qty. 4
Countersink Flat Head Screw
1/4"x3/4"
Ignition Battery Installation - See Figure 3
1. Remove the Ignitor Cap located on the grill
Control Panel.
2. Place the supplied AA battery into the Ignitor
Slot. Be sure to place the positive pole facing
toward you. See Figure 3.
3. Place the Cap and Spring over the AA battery
then tighten the Ignitor Cap onto the grill
Control Panel.
Figure 3
4. Repeat step 1 through 3 to install
AA battery into the Ignitor Slot.
the other
IMPORTANT: Remove any protective film
from outside and inside of Grill Head.
Before use of this grill please refer to
Cleaning Exterior Stainless Steel Surfaces
found on page 18 of this Owner's Manual.