To replace belt – Kenmore 116.25513 User Manual

Page 17

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

TO REPLACE BELT

1. Install new
belt over
motor drive,

then over

belt pulley.

NOTE:

See

PARTS AND
FEATURES

for belt num

ber.

Motor
Drive

Belt
Pulley

Agitator End Cap

2. Place agitator
assembly back into

Power-Mate®.

Caver

Base

3. Line up
front of
cover and
base. Rest
cover on
front edge of
base as
shown.

4. Rotate cover

back. Press

cover firmly until
side and rear
tabs snap Into

place.

Make sure there
Is no gap
between the cover and base.

5. Turn Power-Mate® upside down and
replace two (2) cover screws.

1. Remove Power-Mate® cover as shown in
BELT CHANGING AND AGITATOR CLEAN
ING section.

2. Push in and turn
bulb counterclock

wise, then pull out

to remove.

3. Push in and turn

bulb clockwise, to
replace. Bulb must

not be higher than

15Watts(130Volts).

4. Reinstall Power-Mate® cover as shown in
BELT CHANGING AND AGITATOR CLEAN

ING section.

NOTE:

See PARTS AND FEATURES for

bulb number.

This manual is related to the following products: