Howyour vacuum cleaner works, How your vacuum cleaner works, Caution – Kenmore 116.25513 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
HOWYOUR VACUUM CLEANER WORKS
The vacuum cleaner creates suction that
picks up dirt. Rapidly moving air carries the
dirt to the dust bag through the airflow pas
sages. The dust bag lets the air pass
through, whiie it traps the dirt.
For best cleaning results, keep the
airflow passage open. Check the
starred areas occasionally for
clogs. Unplug from outlet
before checking.
For best cleaning results, the dust bag
should be changed often. The performance
indicator wiil come on when the bag needs
to be changed or the airflow is blocked.
NOTE; See PARTS AND FEATURES for
Bag Number.
1. Unplug cord from wall outlet.
2. Remove hose
from canister.
3. Pull hood
release out and up,
then lift canister
hood.
red bag mount by
pulling away and lifting
up.
5. Pull bag out of the
red bag mount.
4. Disengage
cardboard tab from
6. Check the
motor safety
filter and
replace, if
necessary.
7. The red bag mount will flip forward after
removing bag. This will prevent the lid from
closing until a new bag is installed.
Note: DO NOT bend or crease the middle
of the cardboard when installing the bag
into the bag mount slots.
8. Rotate red bag
mount down and install
bag into slots per
instructions pushing
down until the
cardboard tab locks
into position and the
holes align. Tuck the
bag securely into the bag cavity so that none
of it is able to be pinched by the hood.
9. Close and latch canister hood.
10. Reinstall hose.
11. Plug cord into wall outlet.
A
CAUTION
13
NEVER REUSE A DUST BAG. Very fine
materials, such as carpet freshener,
face powder, fine dust, plaster, soot,
new carpet lint, etc. can clog the bag
and cause it to burst before it is full
and may cause damage to vacuum
motor. Change bag more often when
vacuuming these materials.