Kenmore 116.25513 - Manual (Page 14)

r
CLEANING EXTERIOR AND ATTACHMENTS
1. Unplug cord from wall outlet. DO NOT
drip water on cleaner.
2. Clean exterior using a clean, soft cloth
that has been dipped in a solution of mild
liquid detergent and water, then wrung dry.
Wipe dry after cleaning.
3. To reduce static electricity and dust build­
up, wipe outer surface of vacuum cleaner
and attachments.
A
CAUTION
Do not use attachments if they
are wet. Attachments used in
dirty areas, such as under a
refrigerator, should not be used
on other surfaces until they are
washed. They could leave marks.
MOTOR SAFETY FILTER CHANGING
Check motor safety filter occasionally and
change when dirty.
A
WARNING
Electrical Shock Hazard
Unplug power cord from electrical
outlet. Do not operate the vacuum
cleaner without the motor safety
filter. Be sure the filter is dry and
properly installed to prevent motor
failure and/or electrical shock.
Remove the bag as outlined in the BAG
CHANGING section.
MOTOR SAFETY FILTER
ELECTROSTATIC
This filter must be replaced when dirty. It
should be replaced regularly depending on
use conditions. The filter CANNOT be
washed as it will lose its dust trapping
ability.
NOTE: See PARTS AND FEATURES for
motor safety filter number.
1. Lift the rubber
retainer and pull
out motor safety
filter as shown.
2. Replace the fil­
ter, white side out,
facing the dust bag,
by sliding it back
into place under
the ribs in the bag
cavity. Tuck filter in
so that ft fits com­
pletely under the
rubber retainer.
3. Replace the bag as outlined in the BAG
CHANGING section.
14