Instructions, To set the clock (example below for 1:30), Changing between 12 or 24 hour time of day display – Kenmore 790.4802 User Manual
Page 8: Ic-uu, Setting silent control operation, Press, For 7 seconds, Display, I j - n n, Setting the oven controls
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PRESS
CD(D®
The (^) pad is used to set the clock. The clock may be set for 12 or 24 hour time of
day operation. The clock has been preset at the factory for the 12 hour operation. When
the range is first plugged in, or when the power supply to the range has been interrupted,
the timer in the display will flash (See Fig. 1).
INSTRUCTIONS
To set the clock (example below
for 1:30)
1
. Press (^).
"CLO"
will appear in the display (Fig. 2).
2. Press
pads to set the time of day to 1:30 (Fig.
3). Press
"CLO"
will disappear and the clock will start
(Fig.
4).
Changing between 12 or 24 hour time
of day display
1. Press and hold (^) for 7 seconds until
"12h"
or
"24h"
appears in the display.
2. Press to switch between the 12 and 24 hour time of day
display.
"12h"
(Fig. 5) or
"24h"
(Fig. 6) will be displayed.
3. Press to accept the change or press to reject the
change.
4. Reset the correct time as described in
To set the Clock
above. Please note that if the 24 hour time of day mode was
chosen, the clock will now display time from 0:00 through
23:59 hours.
Setting the Oven Controls
Setting the Clock
for 7 seconds
START") or (
stop
I j - n n
IC-UU
Fig. 1
DISPLAY
Fig. 2
n n n
U LLU
Fig.3
J
Fig. 4
Fig. 6
Setting Silent Control Operation
The
DELAY TIME
and
FLEX CLEAN
pads control the Silent Control operation feature. The Silent Control
operation feature allows the oven control to be operated without sounds or beeps whenever necessary. If desired the
control can be programmed for silent operation and later returned to operating with all the normal sounds and beeps.
2
.
INSTRUCTIONS
To change control from normal sound operation to
silent control operation
1. To tell if your range is set for normal or silent operation press
and hold (|^ for 7 seconds (Fig. 7).
Press to switch between normal sound operation and
silent operation mode. The display will show either
"SP"
(Fig.
8) o r ( F i g . 9).
If
"SP"
appears (Fig. 8), the control will operate with normal
sounds and beeps. I f a p p e a r s (Fig. 9), the control is in the
silent operation mode.
Press to accept the change or press to reject the
change.
3.
PRESS
for 7 seconds
Tiex'
START) or (
stop
DISPLAY
Fig. 7
Fig. 8
Fig. 9