Kenmore 790.4802 - Manual (Page 27)

Seif-Cleaning
Seif-Clean Cycle Time Length
The FLEX CLEAN pad controls the Self-Cleaning feature. When used with a
the Delay Start pad, a delayed Self-Cleaning cycle may also be
programmed. The Flex Clean feature allows for any Self-Cleaning cycle time from
2 (2:00) to 4 hours (4:00). You may also choose the clean time in 1 minute
increments (for example 2 hours and 50 minutes) by pressing the number keypads
©CD®-
If you are planning to use the oven directly after a self-clean cycle remember to allow
timeforthe oven to cool down and the oven door to unlock. This normally takes about
one hour. So a 3 hour self-clean cycle will actually take about 4 hours to complete.
*lt is recommend to use a 2 hour self-clean cycle for light soils, a 3 hour cycle for
average soils, and a 4 hour cycle for heavy soils (to assure satisfactory results).
PRESS
ik CAUTION To avoid possible
burns use care when opening the
oven door after the Self-Cleaning
cycle. Stand to the side of the
oven when opening the door to
allow hot air or steam to escape.
ik CAUTION DO NOT force the
oven door open. This can
damage the automatic door
locking system. Use caution and
avoid possible burns when
opening the door after the
Self­
Cleaning cycle has completed.
The oven may still be VERY
HOT.
DISPLAY
g . f i n r i „
D U U L L n
®®®c
®®®
Fig. 1
n n ^
u l l o
INSTRUCTIONS
To start an immediate Self-Cleaning cycle or to set a
Delay Start time of 9:00 o’clock and shut-off
automatically (example provided is a default 3 hour
Self-Clean cycle)
1. Be sure the clock is set with the correct time of day, the oven is
EMPTY and the oven door is closed.
2. Press (^. "CLEAN" will flash and "3:00" HR will show in the
display (Fig. 1). The control will automatically clean for a 3 hour
period (default self-cleaning cycle time). Note: If a 2 or 4 hour
clean time is desired, press for 2 hour or press
C5) (5) (5) for a 4 hour clean time. Set the cleaning time
based on the amount of soil: light, medium or heavy (* See
above).
3. Press <0T). The "DOOR LOCKED" icon will flash; "CLEAN",
icon and the letters "CLn" will remain on in the display
(Fig. 2).
4. As soon as the control is set, the motor driven oven door lock
will begin to close automatically. Once the door has been
locked the "DOOR LOCKED" indicator light will stop flashing
and remain on. Also, the oven icon will appear in the display
(Figure 3).
Note: Allow about 15 seconds for the oven door lock to close.
Note: If the optional delay Self-Clean feature is needed, finish steps 5-7. If Self-Clean is started immediately skip
the remaining steps and continue with “When the Self-Clean cycle is done” on the following page.
Fig. 2
n r i
u
l l o
Fig.3
5. Press i (Fig. 4). Enter the desired Self-Clean starting time
using the number pads (Fig. 5).
6. Press “CIn” icon will turn off; “DELAY”, “DOOR
LOCKED”, “CLEAN” and Cooktop locked icons will remain on.
7. The control will calculate forward from the set start time to
determine when the Self-Cleaning cycle should end. The Self­
Cleaning cycle will turn on automatically at the set time. At that
time the icon “DELAY” will go out; the oven icon will come on,
the start time, “CLEAN” and “CLn” will remain in the display
(Fig. 6)
27
® ®®
- - < ■ * «
■ L L n
Fig. 4
Fig. 6