beautypg.com

To replace the oven light bulb, To adjust oven temperature, Generai саге & cleaning – Kenmore 790.9403 User Manual

Page 23: Adjusting the oven temperature г, Changing the oven light, Care and cleaning of stainless steel (some models)

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Generai Саге & Cleaning

Changing the Oven Light

The oven light automatically turns ON when the door Is opened. The oven light

may also be manually operated by pressing the Oven Light switch located on

the upper left control panel.

The oven light bulb is located at the rear of the oven and is covered with a glass

shield held by a wire holder. The glass shield must be in place whenever the

oven is in use.

To replace the oven light bulb:

1.

Turn electrical power off at the main source or unplug the range.

2.

Press wire holder to one side to release the glass shield.

3.

Replace bulb with a new 40 watt appliance bulb.

4.

Replace glass shield over bulb and snap wire holder into place.

5.

Turn power back on again at the main source (or plug the range back in).

6.

The clock will then need to be reset. To reset, see

Setting the Clock and

Minute Timer

in this Use & Care Guide.

CAUTION

Be sure the range is unplugged and all parts are COOL before

replacing oven light. Wear a leather-faced glove for protection against possible I

broken glass.

Care and Cleaning of Stainless Steel (some models)

Adjusting the Oven Temperature

г

Some models are equipped with stainless steel exterior parts. Special care and cleaning are

required

for maintaining the f|*

appearance of stainless parts. Refer to the

Care & Cleaning

table for detailed cleaning instructions.

Youroven control has been precisely setatthefactory. This setting may differ from your previous oven however, so your recipe

times may not give you the results you expect. If you think that the oven is cooking too hot or too cool for your recipe times,

you can adjust the control so that the oven cooks hotter or cooler than the temperature displayed.

To Adjust Oven Temperature:

1. Press Bake ,

2.

Set the temperature to 550°F (287°C) by pressing and holding the .

3.

Within 2 seconds, press and hold ^ until the 2 digitdisplayappears. Release The display now indicates the amount

of degrees offset between the original factory temperature setting and the current temperature setting. If the oven control

has the original factory calibration, the display will read "0."

4.

The temperature can now be adjusted up or down 35°F (17°C), in 5°F steps by pressing and holding the W or "V^ , Adjust

until the desired amount of offset appears in the display. When lowering the oven temperature, a minus sign (-} will appear

before the number to indicate that the oven will be cooler by the displayed amount of degrees.

5.

When you have made the desired adjustment, press (ffi) to go back to the time of day display.

Note:

Oven temperature adjustments made will not change the Self-Cleaning feature temperature.

23

This manual is related to the following products: