To remove oven door, Replace oven door, General care & cleaning – Kenmore 790.9403 User Manual
Page 22: Removing and replacing the lift-off oven door, Special door care instructions
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
General Care & Cleaning
Removing and Replacing the Lift-Off Oven Door
i^CAUTION
The door is heavy. For safe, temporary storage, lay the door flat with
the inside of the door facing down.
To Remove Oven Door:
Fig. 2
1.
2
.
3.
5.
To
1
.
3.
4.
5.
Open oven door completely (horizontal with floor - See Fig. 1).
Pull the door hinge locks on both left and right door hinges down from the oven
frame completely towards the oven door (See Fig. 2). A tool such as a small
flat-blade screwdriver maybe required.
Firmly grasp both sides of oven door along the door sides (Do not use the
oven door handle - See Fig. 3).
Close the door to the broil stop position (the oven door will stop into this
position just before fully closing).
With the oven door in the broil stop position, lift the oven door hinge arms over
the roller pins located on each side of the oven frame (See Fig. 4).
Replace Oven Door:
Firmly grasp both sides of oven door along the door sides (Do not use the
oven door handle - See Fig. 3).
Holding the oven door at the same angle as the removal position, seat the
hook of the hinge arm over the roller pins located on each side of the oven
door frame (See Fig. 4). The hook of the hinge arms must be fully seated onto
the roller pins.
Fully open the oven door (horizontal with floor - See Fig. 1).
Push the door hinge locks up towards and into the oven frame on both left and
right oven door hinges (See Fig. 2) to the locked position.
Close theoven door.
Special Door Care Instructions
Most oven doors contain glass that can break. Read the following
recommendations:
1.
Do not close the oven door until all the oven racks are fully in place.
2.
Do not hit the glass with pots, pans, or any other object.
3.
Scratching, hitting, jarring or stressing the glass may weaken its structure
causing an increased risk of breakage at a later time.
Fig. 4
22