beautypg.com

General care & cleaning, Surfaces how to clean – Kenmore 790.9403 User Manual

Page 20

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

General Care & Cleaning

Cleaning Table

Surfaces

How to Clean

Aluminum (Trim Pieces)

&

Vinyl

Use hot, soapy water and a cloth. Dry with a clean cloth.

Painted and Plastic Control Knobs,
Body Parts, and Decorative Trim

For general cleaning,

use hot, soapy water and a cloth.

For more difficult soils and

built-up grease,

applya liquid detergent directly onto the soil. Leave on soil for 30

to 60 minutes. Rinse with a damp cloth and dry.

DO NOT

use abrasive cleaners

on anyofthese materials; they can scratch. To remove control knobs, turn to the

OFF position; grasp firmly and pull straight off the shaft. To replace knobs after

cleaning, line up the flat sides of both the knob and the shaft; then push the knob

into place.

Stainless Steel, Chrome Control Panel,
Decorative Trim

Before cleaning the control panel,

turnall controls to OFF and remove the control

knobs. To remove, pull each knob straight off the shaft. Clean using hot, soapy

water and a dishcloth. Rinse with a clean water using a dishcloth. Be sure to

squeeze excess water from the cloth before wiping the panel; especially when

wiping around the controls. Excess water in or around the controls may cause

damage to the appliance.To replace knobs after cleaning, line uptheflat sides of

both the knob and the shaft; then push the knob into place.

Clean

stainless steel

with hot, soapy water and a dishcloth. Rinse with clean

water and a cloth.

Do not use cleaners with high concentrations of chlorides

or chlorines.

Do not use harsh scrubbing cleaners. Only use kitchen cleaners

that are especially made for cleaning stainless steel. Always be sure to rinse the

cleaners from the surface as bluish stains may occur during heating that cannot

be removed.

Porcelain Enamel Broiler Pan and
Insert, Door Liner, Body Parts, Wanner
Drawer

(some models)

Gentle scouring with a soapy scouring pad will remove most spots. Rinse with a

1

:

1

solution ofclearwaterand ammonia,

if necessary,

cover difficult spots with an

ammonia-soaked paper towel for 30 to 40 minutes. Rinse with clean waterand a

damp cloth, and then scrub with a soap-filled scouring pad. Rinse and wipe dry with

a clean cloth. Remove all cleaners orthe porcelain may become damaged during

future heating.

DO NOT

use spray oven cleaners on the cooktop.

Porcelain
Coated
Oven

Racks

Porcelain coated Oven Racks may be left in the oven during the Self-Clean cycle.

Iffurthercleaning is required, remove the racks after the oven has cooled & clean

using a mild non-abrasive cleanerfollowing manufacturer's instructions. Rinse with

clean waterand let dry. After the Self-Clean cycleisdone and the oven has cooled,

rub the sides of the oven racks with wax paper or a cloth containing a small amount

of vegetable oil. This will make the racks glide easierintothe oven rack positions.

Oven door

Use soap &waterto thoroughly clean the top, sides and front of theoven door. Rinse

well. You may use a glass cleaner on the outside glass of the oven door.

DO NOT

immerse the door in water.

DO NOT spray or allow water or the glass cleaner

to enter the door vents,

DO NOT use oven cleaners, cleaning powders or any

harsh abrasive cleaning materials on the outside of the oven door.

DO NOT

clean the oven door gasket. The oven door gasket is made of a woven

material, on Self-Cleaning models, which is essential for a good seal. Care should

be taken not to rub, damage or remove this gasket.

Ceramic Cooktop

See Cooktop Cleaning and Maintenance in the

General Care

& Cleaning section.

20

This manual is related to the following products: