Setting the clock, Instructions, Press – Kenmore 790.7890 User Manual
Page 13: Display, Changing between 12 or 24 hour time of day display, I'i hr, Setting the clock -14, C i o
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting the Clock
Setting the Clock
The © pad is used to set the clock. The clock may be set for 12 or 24 hour time of day operation. The clock has been preset
at
the
factory
for
the
12
hour
operation.
When
the
range
is
first
plugged
in,
or
when
the
power
supply
to
the
range
has
been
interrupted, the time in the display will flash.
Press V_y. The display will stop flashing.
INSTRUCTIONS
PRESS
DISPLAY
To set the clock (example below for 1:30)
1.
Press
0
. "CLO"
will appear in the display (Fig. 1).
2. Press
13 0
pads to set the time of day to 1:30 (Fig. 2). Press
The time of day will appear in the display (Fig. 3).
Changing between 12 or 24 hour time of day display
1.
Press and hold ©^ for 7 seconds until
"12Hr"
or
"24Hr"
appears in
the display.
2.
Press
Clean
to switch between the 12 and 24 hour time of day display.
The display will show either
"12Hr"
(Fig. 4) or
"24Hr"
(Fig. 5).
3.
Press to accept the change or press to reject the change.
4.
Reset the correct time as described in
To set the Clock
above. Please
note that if the 24 hour time of day mode was chosen, the clock will
now display time from 0:00 through 23:59 hours.
0
1
3 0
©
for 7 seconds
Flex
Clean
ISTART/
{SfOPj
or press
■nn
C i O
uu
Fig. 1
Fig. 2
Fig. 3
I'i
Hr
Fig.
4
?4Kr
Fig.
5
13