beautypg.com

Drying time is not consistent, Check if, Then – Kenmore ELITE 796.7927# User Manual

Page 30: Clothes take too long to dry

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

TROUBLESHOOTING GUIDE

BEFORE CALLING FOR SERVICE(cont.)

Drying time is not consistent

Check If-

Then...

Heat settings, load size, or dampness of clothing is
not consistent.

The drying time for a load will vary depending on the type of

heat used (electric, natural, or LP gas), the size of the load,

the type of fabrics, the wetness of the clothes, and the condi­
tion of the exhaust ducts and lint filter. Even an unbalanced

load in the washer can cause poor spinning resulting in wet­

ter clothes which will take longer to dry.

Clothes take too long to dry

Check If...

Then...

m

z

o

r
(7)

Exhaust ducts blocked, dirty, or duct run is too long.

Confirm that the exhaust ductwork is properly configured and

free of debris, lint, and obstructions.

Make sure that outside wall dampers can open properly and

are not blocked, jammed, or damaged.

Load is not properly sorted.

Separate heavy items from lightweight items. Larger and
heavier items take longer to dry. Light items in a load with
heavy items can fool the sensor because the light items dry

faster.

Large load of heavy fabrics.

Heavy fabrics take longer to dry because they tend to retain
more moisture. To help reduce and maintain more consistent

drying times for large and heavy fabrics, separate these items

into smaller loads of a consistent size.

Dryer controls are not set properly.

Use the appropriate control settings for the type of load you

are drying. Some loads may require an adjustment of the
dry level for proper drying.

Lint filter needs to be cleaned.

Remove the lint from the filter before every load. With the lint
removed, hold the filter up to a light to see if it is dirty or

clogged. If it looks dirty, follow the cleaning instructions on
page 28. With some loads that produce high amounts of lint,

it may be necessary to pause the cycle and clean the filter

during the cycle.

House fuse is blown, circuit breaker has tripped, or
power outage has occurred.

Reset circuit breaker or replace fuse. Do not increase fuse

capacity. If the problem is a circuit overload, have it corrected
by a qualified electrician.

Dryer is overloaded.

Divide extra large loads into smaller loads for better drying
performance and efficiency.

Dryer is underloaded.

If you are drying a very small load, add a few extra items to

ensure proper tumbling action. If the load is very small and

you are using Auto Dry cycles the electronic control cannot

properly sense the dryness of the load and may shut off too
soon. Use timed dry or add some extra wet clothes to the
load.

30

This manual is related to the following products: