beautypg.com

A warning – Kenmore ELITE 796.7927# User Manual

Page 27

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

HOW

то

USE

STEAM FUNCTIONS

To Fill the Steam Feeder

О

Pull out the drawer.

©SI ide the lever forward to the OPEN position and lift

out the steam feeder.

0

Open the lid, then fill the steam feeder up to the

filter screen with tap water.

О

PI ace the steam feeder into position, then slide the

lever to the rear or push the steam feeder to the
rear so it is fully seated.

V>
3

О

z

Ш

IMPORTANT NOTES ABOUT STEAM CYCLES

Add Water

Timed Dry

Before using a Steam Cycle, the steam feeder must be filled with water up to the filter

screen. If not, the ADD WATER light will blink. Make sure that the steam feeder Is filled with
water and fully seated. Turn the dryer off then restart the Steam Cycle. When steam Is used
for the first time. It Is possible that the steam feeder may not have enough water and the
ADD WATER light will come one. Refill the feeder and restart the cycle.

• Oniy use water. Do not fiii the steam feeder with foreign substances, rinse agents, or detergents.
• Before moving the dryer, make sure the steam feeder is empty.
• Do not use distiiied water; the water ievei sensor in the steam generator wiii not work.
• Be careful to put the Steam Feeder otherwise water will be overflow.
• Wipe up any spilled water around the Steam Feeder and the drawer before starting the dryer.

A WARNING:

• Do not fill the steam feeder with liquids such as gasoline, dry-cleaning solvents, or other flammable or explosive sub

stances. They give off vapors that could explode.

• Do not fill the steam feeder with hot water (over 86°F/30°C).
• Do not drink water from the steam feeder.
• During steam operation, the clothes will be tumbled only for a few seconds once a minute.

27

This manual is related to the following products: