Control panel features, 0 0 o, O power (on/off) button – Kenmore ELITE 796.7927# User Manual
Page 19: 0 cycle selector knob and cycles, 0 start/pause button, 0 option buttons, 0 cycle modifier buttons, 0 time and status display, 0 steam functions, My cycle
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
HOW TO USE
WARNING:
To reduce the risk of fire, electric shock, or Injury to persons, read this entire
manual. Including the Important Safety Instructions, before operating this dryer.
CONTROL PANEL FEATURES
0
0
o
PO’ VER
OPTIONS
More Time |
' ...................
I My Cycle ,
Less Time
I Wrinkle Guard
I i
Easy Iron
j Static Shield
^
Damp Dry Signal i Chime ;
Drum Light
} Control
I
Normal
Buiky/Bedding
Casual
Heavy Duty
Towels
Sanitize
o
i
O POWER (On/Off) BUTTON
Press to turn the dryer ON. Press again to turn
the dryer OFF.
NOTE:
Pressing the Power button during a cycle
will cancel that cycle and any load settings will be lost.
0
CYCLE SELECTOR KNOB AND CYCLES
The CYCLE SELECTOR KNOB is used to select the
desired dry cycle by rotating the knob in either direc
tion until the desired cycle LED is illuminated. Once
the desired cycle has been selected, the standard
presets for that cycle will be shown in the display.
These settings can be adjusted using the Cycle
Modifier or Option buttons anytime before starting the
cycle. (See the Cycle Guide on
page 21
for allowable
settings. To protect your fabrics, not all settings are
allowed in all cycles.)
0 START/PAUSE BUTTON
Press the START/PAUSE button to begin the cycle.
The display will change, and the dryer will display the
estimated time (AUTO DRY) or set time (TIMED
DRY) remaining and start tumbling. To pause the
cycle at any time, open the dryer door or press the
START/PAUSE button. To resume the cycle where it
was stopped, press START/PAUSE again.
NOTE:
If the dryer has been stopped for more than
4 minutes, the dryer will turn off automatically and all
settings will be lost.
0
OPTION BUTTONS
The option buttons allow you to select additional
cycle options. The controls can be locked or
unlocked by pressing and holding the Control Lock
button for 5 seconds.
MORE TIME and LESS TIME options are not
available with Auto diy cycles.
For detailed information about the individual options,
please see the following pages.
J Workout Wear
! Small Load
,.j Délicates
I Express Dry
I Touch Up
I Air Dry
I! Rack Dry
PAUSE
0
CYCLE MODIFIER BUTTONS
Use these buttons to modify the settings for the
selected cycle. The lights above the buttons show the
current selection.
See page 24
for a complete
description
NOTE:
Some settings are not allowed on some
cycles.
0
TIME AND STATUS DISPLAY
The display shows the estimated time remaining and
the cycle status. The display also monitors the vent
status. See
page
23 for a complete description.
0
STEAM FUNCTIONS
Steam technology allows you to inject fabrics with a
swirling jet of hot steam to refresh clothes and
reduce static. Simply select the STEAM REFRESH
cycle or select either the STATIC SHIELD or EASY
IRON option.
NOTE:
The Static Shield and EASY IRON options
are not available on all cycles. See pages 26-27 for
steam function details.
(A
3
o
z
u
MY CYCLE
If you have a special combination of settings that you
use frequently, you can save these settings as a
MY CYCLE.
19