beautypg.com

Installation, Instructions, Awarning – Kenmore 110.4292 User Manual

Page 8: Installation instructions, Flernoh'^" ^ ■■.■/stbiii

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Do not ground to a gas pipe.

Check with a qualified electrician if you are not sure the
washer is properly grounded.

Do not have a fuse in the neutral or ground circuit.

1. 3 prong grounding plug

2. 3 prong grounding-type

wall receptacle

3. Grounding prong
4. Power supply cord

GROUNDING INSTRUCTIONS

For a grounded, cord-connected washer:

This washer must be grounded. In the event of a
malfunction or breakdown, grounding will reduce the

risk of electrical shock by providing a path of least
resistance for electric current. This washer is
equipped with a cord having an equipment-grounding

conductor and a grounding plug. The plug must be
plugged into an appropriate outlet that is properly
installed and grounded in accordance with all local
codes and ordinances.

WARNING:

Improper connection of the

equipment-grounding conductor can result in a risk of
electric shock. Check with a qualified electrician or
serviceman if you are in doubt as to whether the
appliance is properly grounded.

Do not modify the plug provided with the appliance -
if it will not fit the outlet, have a proper outlet installed
by a qualified electrician.

For a permanently connected washer:

This washer must be connected to a grounded metal,
permanent wiring system, or an equipment grounding
conductor must be run with the circuit conductors and
connected to the equipment-grounding terminal or
lead on the appliance.

INSTALLATION

INSTRUCTIONS

flernoh'^" ^

■■.■/stBiii

AWARNING

Excessive Weight Hazard

Use two or more people to move and install

washer.

Failure to do so can result in back or other injury.

IMPORTANT: Position the washer so that the rear of the unit is
within approximately 3 ft (90 cm) of the final location.

There are 4 bolts in the rear panel of the washer that support the
suspension system during transportation. These bolts also retain
the power cord inside the washer until the bolts are removed.

I

«»

1

.

2

.

Using a 13 mm wrench, loosen each of the bolts.

Once the bolt is loose, move it to the center of the hole and
completely pull out the bolt, including the plastic spacer
covering the bolt. The power cord will be attached to all
4 bolts inside the washer.

3.

Once all 4 bolts are removed, pull the power cord through the

opening of the rear panel and close the hole with the attached
cap.

4.

Close the bolt holes with the 4 transport bolt hole plugs.

NOTE: If the washer is to be transported at a later date, call

your local service center. To prevent suspension and structural
damage, your machine must be properly set up for relocation

by a certified technician.

This manual is related to the following products: