Installation clearances, Washer dimensions – Kenmore 110.4292 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installation clearances
■ The location must be large enough to allow the washer door
to be fully opened.
■ Additional spacing should be considered for ease of
installation and servicing.
■ Additional clearances might be required for wall, door, and
floor moldings.
■ Additional spacing of 1 in. (2.5 cm) on all sides of the washer
is recommended to reduce noise transfer.
■ Companion appliance spacing should also be considered.
Washer Dimensions
Recessed or closet installation - Washer on pedestal
Recommended installation spacing for custom
undercounter installation
The dimensions shown are for the recommended spacing.
Custom undercounter installation - Washer only
Recommended installation spacing for recessed or
closet installation, with or without a pedestal
The dimensions shown are for the recommended spacing.
Recessed area or closet installation
□
6.4
cm)
(310
cm
(
7
,ecm)
(
7.6
cm)
1. Recessed area
2. Side view - closet or confined area
Recommended installation spacing for recessed or
closet installation, with stacked washer and dryer
The dimensions shown are for the recommended spacing.
48 in.^ *
*Min. top and bottom air openings for closet door.
'External exhaust elbow requires additional space.
’'Wall, door and floor molding may require
additional spacing.
I
1
"
31
íé" H
4
"
!
2
.
5
cni) (&
0
cm) (
10.2
cm)
1. Side view - closet or confined area
2. Closet door with vents