Cleaning recommendation table, Care & cleaning – Kenmore 790.9280 User Manual
Page 32
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Cleaning recommendation table
Care & Cleaning
Surface type
Recommendation
Control
knobs
Painted body parts
Painted decorative trim
Aluminum, plastic or vinyl trim
pieces
For general cleaning, use hot, soapy water and a cloth. For more difficult soils and
built-up grease, apply a liquid detergent directly onto the soil. Leave on soil for 30
60 minutes. Rinse with a damp cloth and dry.
Do not
use abrasive cleaners on any of
these materials; they can scratch. To remove control knobs, turn to OFF position;
grasp firmly and pull straight off the shaft. To replace knobs after cleaning, line up
the flat sides of both knob and shaft; then push knob into place.
Control panel
Control
key
pad membrane
Decorative trim
(some models)
Before cleaning the control panel, turn all controls OFF, activate oven lockout (on
some models) and if needed remove any knobs from panel.
Do not
use abrasive
cleaners on any of these materials; they can scratch. Clean using hot, soapy water
and a dishcloth. Be sure to squeeze excess water from dishcloth before wiping
control panel; especially when wiping around the controls area. Excess water in or
around the controls may cause damage to the appliance. When rinsing, use clean
water and a dishcloth and be sure to squeeze excess water from dishcloth before
wiping the control panel.
Porcelain enamel parts & door
liner
Gentle scubbing with a soapy no-scratch cleaning pad will remove most spots. Rinse
with a 1:1 solution of clear water and ammonia. If necessary, cover difficult spots
with an ammonia-soaked paper towel for 30 to 40 minutes. Rinse with clean water
and a damp cloth, and then scrub with a soap-filled no-scratch cleaning pad. Rinse
and wipe dry with a clean cloth. Do not allow food spills with high sugar or acid
content (milk, tomatoes, sauerkraut, fruit Juices or pie filling) to remain on the
surface; they may cause a dull spot even after cleaning.
Oven interior
For oven interior remove excessive spillovers from oven cavity bottom before
starting Flex Clean. Clean any soils from oven frame and door liner outside the oven
door gasket. For very important cleaning precautions be sure to read all the
instructions in the Flex Clean section.
Oven racks
Remove oven racks from oven cavity before starting Flex Clean. Clean by using a
mild, abrasive cleaner following manufacturer's instructions. Rinse with clean water,
dry and then replace in oven.
Oven door
Use soap & water to thoroughly clean the top, sides and front of the oven door.
Rinse well. You may use a glass cleaner on the outside glass of the oven door.
Do
not
immerse the door in water.
Do not
spray or allow water or the glass cleaner to
enter the door vents.
Do not
use oven cleaners, cleaning powders or any harsh
abrasive cleaning materials on the outside of the oven door.
Ceramic cooktop
Do not use spray oven cleaners on the cooktop. See “Cooktop cleaning” and
“Cooktop maintenance” later in the Care & Cleaning section.
Stainless Steel
(some models)
Only use cleaners and polishes that are specifically manufactured for cleaning
stainless steel. Always rub in direction of metal grain to avoid damaging.
Do
not
use
cleaners with high concentrations of chlorides or chlorine. Do not
use harsh
scrubbing cleaners. Polish with a lint-free cloth. Always be sure to wipe excess
cleaner/polish off from the metal surface as bluish stains may occur during future
oven heating that cannot be removed. Clean heavier soils with hot, soapy water and
a dishcloth. Rinse and dry using clean water and a cloth.
32