Warmer drawer indicator light, Setting warmer drawer, Setting warmer drawer control – Kenmore 790.9280 User Manual
Page 29
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting Warmer Drawer Control
Warmer drawer indicator light
The indicator light is located above the Warmer Drawer
thermostat control knob. It turns on when the control is set,
and stays on until the control is turned OFF.
Setting warmer drawer
The thermostat control knob is used to select the
temperature for the warmer drawer. It is located on the
control panel. The temperatures are approximate, and are
marked LO, MED and HI (See Fig. 1).
A WARNING
FOOD POISONING HAZARD.
Do not let
food sit for more than one hour before or after cooking.
Doing so can result in food poisoning or sickness.
WARMER DRAWER
ii CAUTION
I
Always use potholders or oven mitts when
removing food from the warmer drawer as cookware and
plates will be hot and you can be burned.
Important notes:
• Always start with hot food when using the warmer
drawer.
DO NOT
heat cold food in the warmer drawer.
To set warmer drawer:
1. Open warmer drawer when cool and arrange warmer
drawer rack as needed.
2. For best results, close the warmer drawer and preheat
the drawer before adding food or plates. An empty
warmer drawer will fully preheat in approximately 15
minutes.
• Flex Clean can not be set when the warmer drawer is
active.
• The warmer drawer is equipped with a catch that may
require extra force to open and close the drawer.
3. Place food in warmer drawer that is already at serving
temperature on warmer drawer rack. Dinner plates may
be warmed also.
4. Push in and turn the warmer drawer control knob in
either direction to the desired temperature setting (See
Fig. 1).
5. Always turn warmer drawer control knob to
OFF
position after use.
29