The oven light, Removing the oven door (contd.) – Kenmore Sens-A-Clean 665.95829 User Manual
Page 44
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
REMOVING THE OVEN DOOR (contd.)
2.
Hold oven door so that the top edge of each
hinge hanger is horizontal. Insert hinge hangers
into the front frame hinge slots.
3.
Tilt top of door toward range. Slide hinge
hangers down onto front frame support pins.
NOTE: Make sure the hinge hangers are fully
seated and engaged on the support pins.
4. Insert the door stop clip with the angular surface
at the top of the frame hinge slot, then push in
the bottom of the clip until flanges are flush with
the front frame.
5.
Open the door completely and remove the door
removal pins. Save door removal pins for future
use.
6
.
Close the door.
7.
Check for alignment to make sure door is
installed evenly.
THE OVEN LIGHT
5 The oven light will come on when you open the
: oven door The oven light will not work during the
5 Self-Cleaning cycle.
Press the OVEN pad.
"O
-S’ w ?
1. Unplug range or disconnect power.
2.
Remove the glass bulb cover in the back of the
4.
Replace the light bulb cover by turning it clockwise.
oven by turning it
counterclockwise.
3.
Remove the light bulb from its socket by turning
it counterclockwise. Replace the bulb with a
40-watt appliance bulb.
5.
Plug in range or reconnect power.
44