The oven vent, Using the warm & ready warming drawer (contd.) – Kenmore Sens-A-Clean 665.95829 User Manual
Page 36
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
USING THE WARM & READY WARMING DRAWER
(contd.)
Remove ail items from inside the warming drawer
and allow the unit to cool completely before
attempting to remove the drawer.
1. Pull drawer to its full open position.
2.
Locate the black triangle tabs on each side of
the drawer.
1. Align the drawer glides with the receiving
guides.
2.
Push drawer in completely.
3.
Gently open and close drawer to ensure it is
seated properly on the slides.
3.
Press the tab DOWN on the RIGHT side and lift
the tab UP on the LEFT side at the same time.
Then pull drawer out another inch.
4.
Carefully pull the drawer all the way out holding
on to the sides, not the drawer front.
THE OVEN VENT
Hot air and moisture escape from the oven through
a vent on the backguard below the control panel. The
vent lets air circulate properly. Be careful not to
block the vent, or you will get poor baking/roasting
results.
NOTE: Never store plastics, paper, or other items
that could melt or burn near the oven vent, or any
of the surface cooking zones.
36