Kenmore 9744231 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
continued from page 8
Direct wire method:
Cut a 3/4’ (1.9cm) hole © in right-hand
cabinet side, rear or floor. Optional
locations are shown.
Wood cabinet:
Sand hole until smooth.
Metal cabinet:
Cover hole with
Grommet (Part No. 302797) available
from your Sears store or service center.
4,
Run wire into house wiring junction
box. Use strain relief method provided
with junction box. If no strain relief is
provided, install a U.L.-listed/CSA-
certified clamp connector for flexible-
type wire. If installing conduit, attach a
U.L.-listed/CSA-certlfied conduit
connector to junction box.
4a.
Run other end of wire through cabinet
hole. Cable must extend to the right
front of cabinet opening. Go to step 6.
Power supply cord method:
Cut a 1-1/2" (3.8cm) hole © in right-
hand cabinet rear or side. Optional
locations are shown.
Wood cabinet:
Sand hole until smooth.
Metal cabinet:
Cover hole with
Grommet (Part No. 302797) available
from your Sears store or service center.
Install a mating, three-prong,
grounding-type wall receptacle © in the
cabinet next to the dishwasher opening.
Go to step 6.