Warning, Handle assembly, Assembly bnstructions – Kenmore 116.32289 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY BNSTRUCTIONS
Before assembling vacuum, check the
PACKING LIST on the cover of the separate
Repair Parts List., Use this list to verify that
you have received a!! the components of
your new Kenmore vacuum.
A
WARNING
Electrical Shock Hazard
Do not plug into the electrical sup
ply until the assembly is complete.
Failure to do so could result in
electrical shock or injury.
HANDLE ASSEMBLY
Before assem
bling your vacu
um cleaner be
sure you have a
the parts shown
Handle
Cord
Hooks
Opening
for Handle
Handle
Screw
Hole
Back of
Vacuum
Cleaner
Remove the screw located just below the
carry handle on the back side of
the vacuum.
Position the
handle so
the cord
hooks are
toward the
back of the
cleaner.
Insert the
handle into
the opening
at the top
of the vacu
um.
Corti
Hooks
Screw
Hole
Handle
Screw
Hole
Align the screw hole in the handle with
the screw hole in the vacuum.
Insert the screw so it passes through the
back of the vacuum into the handle ,
Begin to tighten the screw with your fin
gers, It may be necessary to adjust the
handle slightly.
Using a screwdriver, tight
en the screw,
Do not overtighten.
Overtightening could strip the
screw holes.
Do not operate the cleaner without
the screw in place.