beautypg.com

Belt routing – Kenmore 116.32289 User Manual

Page 18

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

BELT ROUTING

Correct Routing of Belt

(Selector in Carpet Position)

K

Brush

Assembiy

>

} Carpet/Bare

—I " Floor Pedal

Motor

Carpet/Bare Floor Shaft
Selector Shaft

Brush

Incorrect Routing of Belt

(Belt on Selector Shaft)

,1.^, Carpet/Bare

i

Floor Pedal

Motor

Assembly carpet/Bare Floor Shaft

Selector Shaft

Incorrect Routing of Belt

(Selector in Bare Floor Position)

Carpet/Bare

Floor Pedal

y

sJ-

Assembly

Carpet/Bare Floor
Selector Shaft

Press firmly, checking to see that each

end is completely inserted.

Belt

Agitator—-
Assembly

Check to see that the belt is centered in
the belt groove. Turn the brush assembly
with your fingers to see that it turns freely.

To re-attach the base plate, insert the
tabs into the slots along the front edge of
the base. Place the vacuum in full upright

position. Lower the base plate to its origi­
nal position.

Full Upright Position

Tab Locations

As the base is lowered the inner areas
will brush against the dust compartment
wheels. A gentle pull outward may assist

in reassembly.

Two Locking Tabs

Press the
base plate

down until
the two

locking tabs

snap into

place.

Screws

Re-install the

two screws
that secure
the base

plate.

Return the cleaner to the upright position
before plugging into the electrical outlet.

18

This manual is related to the following products: