beautypg.com

Motor safety filter cleaning, To remove bag, To replace bag – Kenmore 116.32289 User Manual

Page 14: Motor safety filter cleaning -15, Warning, Caution

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

MOTOR SAFETY FILTER CLEANING

Check motor safety filter frequently and
clean when dirty.

WARNING

Electrical Shock Hazard

Do not operate the cleaner without
the motor safety filter. Be sure the

filter is dry and properly installed
to prevent motor failure and/or

electrical shock.

Always unplug power cord from

electrical outlet before performing
any service on vacuum.

TO REMOVE BAG

Press the release

Release

button located on

Button

the top of the bag
cover.

Bag —

Cover

Pull the bag

cover forward.

Remove and lay

aside.

Grasp the
dust bag
collar and
pull gently,
carefully
removing

the dust
bag.

Dust
Bag

Safety
Seal Tab

If the motor safety filter, located in the bot­

tom of the dust bag cavity is dirty, remove it
by pulling forward out from under the ribs.

Wash the foam filter In warm soapy water,

rinse and dry thoroughly by squeezing the

filter in your hand and letting it air dry,

DO NOT wash in the dishwasher.

DO NOT install damp.

Replace the foam filter by sliding it back into
place under the ribs in the dust bag cavity.

TO REPLACE BAG

Dust Bag

Safety
Seal Tab

Fold the
safety seal

tab on the

new bag
away from the

opening that
fits on the dirt
tube,

A

CAUTION

NEVER REUSE A DUST BAG. Very

fine materials, such as carpet
fresheners, face powder, fine dust,
plaster, soot, etc. can clog the bag
and cause It to burst before it is

full. Change bag more often when

vacuuming these materials.

14

This manual is related to the following products: