beautypg.com

Figure 1, Cleaning the burner tubes and burner ports – Kenmore 141.16322 User Manual

Page 23

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

CLEANING THE BURNER TUBES AND BURNER PORTS

To reduce the chance of FLASHBACK FIRE you must
clean the Burner Tubes as follows at least once a month

in summer and fall or whenever spiders are active in your
area, and if your grill has not been used for an extended
period of time.

1. Turn all Burner Valves to the full OFF position.

2. Turn the LP Gas tank valve to the full OFF position.

3. Detach the LP Gas regulator assembly from your

gas grill.

4. Remove the Cooking Grids, Savor Plates® and

Grease Trays from your grill.

5. Remove the screw from the rear of each Burner

using a Phillips Head Screwdriver.

6. Carefully lift each Burner up and away from the

Gas Valve Orifice.

7. Check and clean burner/venturi tubes for insects

and insect nests. A clogged tube can lead to a fire

beneath the grill.

8. Refer to Figure 1 and perform one of these

three cleaning methods:

□ METHOD 1: Bend a stiff wire or wire coat

hanger into a small hook as shown and
run the hook through the Burner Tube and
inside the Burner several times to remove

debris.

c

□ METHOD 2: Use a bottle brush with a

flexible handle and run the brush through
the Burner Tube and inside the Burner
several times to remove any debris.

□ METHOD 3: Use an air hose to force air

through each Burner Tube. The forced air
should pass debris or obstructions through
the Burner and out the Ports.

Regardless of which Burner cleaning procedure you
use, we recommend you also complete the following
steps to help prolong Burner life.

1. Use a fiber pad or nylon brush to clean the entire

outer surface of each Burner until free of food
residue and dirt.

2. Clean any clogged ports with a stiff wire, such as

an open paper clip.

3. Inspect each Burner for damage (cracks or holes)

and if such damage is found, order and install a

new Burner. After installation, check to ensure that

the Gas Valve Orifices are correctly placed inside

the ends of the Burner Tubes. Also check the position

of your Spark Eiectrode.

For safe operation ensure the Gas Valve Assembly
Orifice is inside the Burner Tube before using your
grill. See figure. If the Orifice is not inside the
Burner Tube, lighting the Burner may cause
explosion and/or fire resulting in serious bodiiy
injury and/or property damage.

Gas Valve Assembly

Orifice

BurnerTube

Figure 1

TO CLEAN BURNER TUBE,

iNSERT HOOK AS iNDICATED BY THE ARROW

23

This manual is related to the following products: