Install side burner kit – Kenmore 141.16322 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Install Side Burner Kit
□ Insert the Side burner Gas Valve Assembly into
Side Burner Tube (See Figure 1). Be sure the
orifice is inside the Burner Tube properly (see
warning on Page 3), or lighting the burner may
cause explosion and/or fire.
□
Insert the Side Burner Gas Valve Assembly
through the Side Burner Gas Valve Hole on the
Side Burner Frame. Align the 2 holes on the
Side Burner Frame with the threaded holes on
the Side Burner Gas Valve Bracket. Then insert
the two (2) screws and washers provided and
tighten securely.
□ Fasten the Control Knob onto the Side Burner
Gas Valve Stem. Be sure that the OFF position
faces the Burner.
□
Connect the Electric Wire terminal from Side
Burner with the other from Grill Head as shown.
Bind the connected Electric Wire and Side
Burner Connection Tube together using the
supplied Fastening Band.(Note: located in
Operator's Manual plastic bag).
□ The gap between the Side Burner Electrode Tip
and
the
Side
Burner
Port
should
be
approximately 1/8"~ 3/16". If the gap is wider
than 3/16", use a pair of long nose pliers and
gently bend the Electrode Tip toward the burner.
□
Cut and remove Fastening Band from
Burner and Pot Support before use.
□ Place the Side Burner Pot Support into the Side
Burner Frame.
□ Place the Side Burner Wind Shield on the Side
Burner Frame.
Pattern
Head
Screw
M4x8mm
Qty. 2
Part # S132M04082
Plain Washer M4
Qty. 2
Part # S411IVI04122
Side Burner
Pot Support
Control
Knob
for
Side
Burner
Qty. 1
Part # P03426083H
Scale 1:2
Fastening
Band
Qty. 1