Materials and basic tool-s needed, Materials needed, Additional tools needed when sweat soldering – Kenmore 153.33443 User Manual
Page 6: Materials and basic tools needed, Material needed, Basic tools
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
MATERIALS AND BASIC TOOl-S NEEDED
Materials Needed
To simplify the installation Sears has available the installation parts shown below. You may or may not need all of these materials,
depending on your type of installation.
EXPANSION TANKS FOR
THERMAL EXPANSION
CONDITIONS AVAILABLE
m
2 GALLONS
(7.6 LITERS) AND
5 GALLONS {18,9 LITERS)
CAPACITY HROUGH
LOCAL SEARS STORE
OR SERVICE CENTER.
WATER HEATER INSTALLATION KIT WITH
FLEXIBLE CONNECTORS FOR 3/4”
(19.05 mm) OR 1/2” (12.7 mm) THREADED OR
COPPER PLUMBING AND FLEXIBLE WATER
HEATER GAS CONNECTOR WITH FITTINGS.
DRAIN PANS AVAILABLE IN
20” (508 mm) DIAMETER FOR
WATER HEATERS HAVING A
DIAMETER 18” (457 mm) OR
LESS, 24” {610mm) DIAMETER
FOR WATER HEATERS HAVING
A DIAMETER 22” {559 mm) OR
LESS AND AVAILABLE IN 28”
(711 mm) DIAMETER FOR
WATER HEATERS HAVING A
DIAMETER 26” (660 mm) OR
LESS.
Basic Tools
You may or may not need all these tools, depending on your
type of installation. These tools can be purchased at your local
Sears Store.
Pipe Wrenches (2) 14” (356 mm)
Screwdriver
Tin Snips
8’ (1.82 m)
Tape
or Folding
Ruler
Garden
Hose
Drill
Pipe Dope or Teflon Tape
SLOT-HEAD SCREWDRIVER
DRILL
TIN SNIPS
PHILLIPS SCREWDRIVER
ROLL OF TEFLON
TAPE (USE ONLY ON
WATER CONNECTIONS)
C
P.fii
PIPE DOPE
{SQUEEZE TUBE)
USE FOR WATER AND GAS
CONNECTIONS
GARDEN HOSE
€ FOOT TAPE
PIPE WRENCH
Additional Tools Needed
When Sweat Soldering
• Tubing
Cutters
or Hacksaw
• Propane Tank
• Soft
Solder
• Solder
Flux
• Emery Cloth
• Wire Brushes
TUBING CUTTER
03CI
HACKSAW
ROLL OF
EMERY CLOTH
3/4" (19 mm) WIRE BRUSH
1/2” (13 mm) WIRE BRUSH
ROLL OF LEAD-FREE
SOFT SOLDER
SOLDER
FLUX