Carl Goldberg GBGA1091 - Manual (Page 8)

8
20.
Locate the rudder and install the hinges using
pins in the holes to make sure the hinges go
half way into the rudder.
21.
Mix some epoxy and force into the hole in the
rudder where the tail wheel tiller are
goes.Install the rudder on the fin and push
hinges in until all pins are against the fin.
Remove the pins and push rudder against the
fin. Make sure rudder tiller arm is in its slot.
Engine Mounting
1.
COLLECT THE FOLLOWING ITEMS
(2) NYLON MOTOR MOUNTS
(2) 4MM X 25MM BOLTS
(2) FLAT WASHERS
2.
Bolt the mounts to the firewall. The blind nuts
are pre-installed. Be sure and use Locktite on
the bolts. The mounts are spaced to fit most
.40 to .46 motors. If yours does not fit you will
have to knock the blind nuts out and reinstall
the mounts to match your engine.
22.
Deflect the rudder to its full travel in one direc-
tion and using thin CA, glue the hinges in
place. Place one drop on each hinge. Deflect
full in the other directions and glue hinges
from the other side. Repeat process so each
hinge gets two drops on both sides.