Braeburn 7390 - Manual (Page 5)

MPEG LA License Agreement
ThIS PRODUCT IS LICENSED UNDER ThE wIRELESS NETwORk PATENT PORTFOLIO LICENSE FOR USE BY A
CONSUMER OR OThER USES FOR whICh ThERE IS NO REMUNERATION. ANY OThER USE OF ThIS PRODUCT
IN ANY MANNER IS NOT LICENSED AND IS ExPRESSLY PROhIBITED wIThOUT A LICENSE UNDER APPLICABLE
PATENTS IN ThE wIRELESS NETwORk PATENT PORTFOLIO, whICh LICENSE IS AVAILABLE FROM MPEG LA, LLC,
4600 S. ULSTER ST., SUITE 400, DENVER, COLORADO 80237 U.S.A. SEE hTTP://www.MPEGLA.COM.
FCC Compliance Statement (Part 15.19) (USA only)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1 This device may not cause harmful interference, and
2 This device must accept any interference received, including interference that may cause undesired operation.
FCC Warning (Part 15.21) (USA only)
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
FCC Interference Statement (Part 15.105 (b)) (USA only)
this equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not in-
stalled and used in accordance with the instructions, may cause harmful interference to radio communications.
however, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Equipment interface module, thermostats and outdoor sensor
To comply with FCC and Industry Canada RF exposure limits for general population/ uncontrolled exposure, the
antenna(s) used for these transmitters must be installed to provide a separation distance of at least 20 cm from
all persons and must not be co-located or operating in conjunction with any other antenna.
Portable Comfort Control
This portable transmitter with its antenna complies with FCC and industry Canada RF exposure limits for general
population/uncontrolled exposure. This device must not be co-located or operating in conjunction with any other
antenna or transmitter.
Section 7.1.2 of RSS-GEN
Under industry Canada regulations, this radio transmitter may only operate using an antenna of type and maxi-
mum (or lesser) gain approved for the transmitter by industry Canada. To reduce potential radio interference to
other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for successful communication.
Section 7.1.3 of RSS-GEN
Operation is subject to the following two conditions:
1 This device may not cause interference, and
2 This device must accept any interference, including interference that may cause undesired operation of
the device.
5 Installer Guide