Blinds Chalet SlumberShade 3/8 Blackout Double Cell Shades - Manual (Page 5)

Continuous Loop Shades
Install Tension Device
The tension device reduces the hazards of
strangulation and entanglement of young children by
limiting access to the control cord.
Attention!
The cord tensioner must be installed to make the
shade fully operable.
Please read the instructions included in the mounting
hardware packet prior to installation.
EQUALIZATION
If the shade length and equalization is satisfactory,
simply trim the excess cord hanging below the
bottom rail.
If adjustments are necessary, pull the excess cord at
the bottom of the shade down until the Bottom Rail
Plug is released. Push the cord up or down through
the Bottom Rail Plug (figs. A & B).
If the cord needs to be longer, slide the bottom end of
the cord up into the wedge and slide the wedge down
to take up slack.
If the cord needs to be shorter, slide the top end of
the cord down into the wedge and slide the wedge up
to take up slack.
Adjust the position of the plug as necessary (fig. C).
Feed the cord back through the Bottom Rail Plug
(figs. D & E).
Push the Bottom Rail Plug back into the Bottom Rail
Pocket.
When bottom rail adjustments have been made, trim
the excess cord hanging below the bottom rail.
B C D E A
Bottom
Rail
Pocket
Bottom Rail
Plug
TROUBLE SHOOTING
Problem: Shade is difficult to operate, especially near
the top.
Cause: Brackets and Side Track may not be properly
aligned.
Repair: Adjust brackets as necessary so the track is
centered in the bottom rail end cap.
CLEANING AND CARE
The Shade fabric is easy to care for. Regular dusting
with a feather duster or vacuum cleaner brush is
recommended. Most stains can be blotted with a
damp sponge and mild detergent. For problem
stains, the shade can be removed from the
Installation brackets and soaked in warm water.
When damp, raise shade tightly to re-crisp pleats.
7 8