Blinds Chalet Eclipse 5% Screen Roller Shades - Manual

Roller Shade
(Chain Operated Clutch)
Installation Instructions
Please follow these Installation Instructions
You will need a pencil, tape measure, drill, screwdriver, pliers, and appropriate fasteners.
Step 1: Choose the Correct Fastener
Step 2: Mark the Bracket Locations
Step 3: Bracket & Shade Installation
Step 4: Safety Tension Device Installation
1 ½” #8 Hex Head
Wood Screws (Included)
Alternative fasteners should be used for aluminum or
concrete installations
(Not Included with Blinds)
Safety Tension Devices are designed to minimize the hazards of
strangulation and entanglement of small children by restricting
access to the chain control. The safety tension device is sent from
the factory already attached to each chain control. Screw the
safety tension device into the wall or window frame with a screw.
Critical Note: The safety device should be installed so that the
bead chain and bead stop balls move smoothly through the opening of
the device. Removal of this device or failure to properly install it, can
cause damage to the clutch lifting mechanism and will result in the void-
ance of the product’s limited lifetime warranty.
Screw the brackets in place. For regular roll shades (fabric is rolled off the back of
the roller), lift the shade up to the brackets with the fabric hanging closest to the
window. For reverse roller shades (fabric is rolled off the front of the roller), lift the
shade up to the brackets with the fabric hanging closest into the room.
Push the spring plunger (side opposite of the chain) into it the bracket as shown in
the above diagram. Push the shade into the bracket, depressing the plunger. With
the clutch hook pointing downward, place the hook into the vertical part of the “+”
shaped hold in the bracket Slightly pull down on the shade so that the clutch hook
locks into place in the bracket.
Position the installation brackets at each end of the roller shade. In the diagram to
the left, bracket positions are illustrated for a shade with a chain control on the
right hand side. For a shade with a chain control on the left hand side, the brackets
should be at the opposite end. Brackets may be mounted to the wall, ceiling, or
inside of the window frame.
Critical Note: Installation brackets must be level to ensure that the fabric will roll
up properly, allowing for smooth operation. Installation brackets must be placed
such that the outer edge of the brackets are 1 ¼” wider than the fabric. Mark the
brackets for mounting hole locations.
(Step 3: Shade Installation)
(Step 2: Mark Bracket Locations)