Blinds Chalet Exterior Solar Sun Screens Plus User Manual
Installation instructions, Corded shade with pe fabric, Maintenance
Corded Shade with PE Fabric
Description
Part Number
Qty Included
Clutch Bracket
CB9
1
Plug Bracket
PB9
1
Bracket Cover
BC9
2
Clutch with cord (pre-installed)
C9
1
Plug with pin (pre-installed)
P9
1
Bottom Rail (pre-installed)
BR9
1
Bottom Rail Caps (pre-installed)
BRC9
2
Fabric
F9
1
Screws (not shown)
SCR9
5
Cord Safety Device
CSD9
1
Bottom Rail Ring (pre-installed)
BRR9
2
INSTALLATION INSTRUCTIONS
Maintenance
To clean your shade simply rinse with water and scrub with any non-abrasive cleaner (us-
ing bleach or other abrasive cleaners will void your warranty). Roll the shade down to air
dry.
Step 4: Install Cord Safety Device
The Cord Safety Device keeps the Cord secure
and reduces the risk of strangulation. The Cord
Safety Device is pre-installed on the Cord.
Install the Cord Safety Device in a location that
keeps the Cord tight (see Fig. K).
If a wood stud is not available, you will need
to use an anchor (not included). See your local
hardware store for more information.
303.652.6164 (p)
Figure K
Moving Cord to left side of the shade
Clutch Bracket
(CB9)
Figure A
M1001-E
Securing your shade
Your shade has Bottom Rail Rings pre-installed on the Bottom Rail. These rings can be
used to secure your shade during slightly windy conditions. You may use a screw, nail,
S-hook, or any other device to secure your shade.
Always roll your shade up during windy conditions.
Clutch (w/ cord)
(C9)
Plug (with pin)
(P9)
Plug Bracket
(PB9)
Bottom Rail Cap
(BRC9)
Cord Safety Device
(CSD9)
Bottom Rail Ring
(BRR9)
Bracket Cover
(BC9)
Fabric
(F9)
Bottom Rail
(BR9)
Tools required: phillips screwdriver, leveling device (laser level, standard level, etc.), and
power drill (if pre-drilling the holes).
Your shade is already prepared for the Cord to be located on the right side of the shade. If
you want to move the Cord to the left side of the shade, you will need to rotate the metal
disc in the Plug Bracket (Fig L).
No change is needed to the Clutch Bracket, you only need to rotate the Clutch so the Cord
hangs down, towards the ground.
www.keystonefabrics.com
Note: your parts and fabric may differ in color than shown in this manual
Figure L
Don’t forget to send us your warranty/registration card.