Blinds Chalet EcoGreen Solar Screen Shades - Manual

R
OLLER
S
HADES
Standard Installation Instructions - April 2007
1) Mount the Brackets
If the clutch is on the right end of the shade, attach the brackets to the window frame,
window molding, wall or ceiling, as shown below. If the clutch is on the left end of the
shade, reverse the bracket positions, left for right.
2) Install the Shade
a. Push the clutch straight onto the blade
of its bracket. The bottom of the clutch
should always point straight down.
b. Lower the lug of the end plug onto
the "V" of its bracket. The roller should
fit in the brackets securely, with just a
little play. Rotate the riveted retainer
portion to lock the lug in position.
The LUG
rests here.
The LUG
rests here.
The LUG rests
here.
After lug is set, rotate
retainer onto lug
After lug is set, rotate
retainer onto lug
After lug is
set, rotate
retainer
onto lug
To the Inside of the
window frame
To the wall or to the front of the
window molding
To the ceiling or to the top
of the window frame
3) Install the Tension Device
The tension device reduces the hazards of strangulation and entanglement of
young children and pets by limiting access to the control cord. Anchor the
tension device that is attached to the shade’s control cord to the window frame
or wall so that young children or pets cannot pull the cord around their necks.
a. Lower the shade.
b. Hold the tension device upright so the Warning Tag hangs straight down as
shown in diagram.
c. Position the tension device on the window frame or the wall so that the
tension device and control cord do not interfere with raising or lowering the
shade. The tension device should be installed without stretching or pulling
down on the control cord. Stretching the cord will cause excessive wear. Do not
twist or cross the control cord. If using stop balls, position the tension device
1 / 4 ”
higher to allow the stop ball to pass thru the tension device.
d. Holding the tension device upright and in position as shown, insert and secure the
screw through the hole. The mounting screw must be secured into a solid surface
or molly.
1.